C18 ACERT™ Offshore Production Engine

C18 ACERT™ Offshore Production Engine

Cat C18 ACERT™ Fire Pump Engines. Ratings: 447-597 bkW (600-800 bhp)@ 1800-1900 rpm meet U.S. EPA Tier 3 or U.S. EPA Tier 2 emission standards for stationary emergency fire pump engines. Rating: 522 bkW (700 bhp) @ 1500 rpm is Non-certified. FM Approved. UL Listed.

Download Product Documents

Engine Specifications

Minimum Rating
600.0bhp
Maximum Rating
800.0bhp
Emissions
U.S. EPA Tier, Tier 2 or non-certified
Rated Speed
1750.0RPM
Bore
5.7in
Stroke
7.2in
Displacement
1106.0in3
Aspiration
Turbocharged-Aftercooled
Engine Weight, net dry
3900.0lb
Oil Change Interval
500.0hr
Rotation (from flywheel end)
Counterclockwise
Flywheel and Flywheel Housing
SAE No. 1
Flywheel Teeth
113

Capacity for Liquids

Lube Oil System (refill)
10.0gal
Cooling System (engine only)
13.3gal

Dimensions

Length
74.4in
Width
43.0in
Height
54.3in

Standard Equipment

  • Air Inlet System
    • Dual turbocharger: front and rear inlet 127.mm (5.0 in)
    • Separate Circuit Aftercooled (SCAC)
  • Charging System
    • Charging alternator 24 volt, 50 amp
  • Control System
    • Dual Electronic Control Units (ECU), primary and secondary
    • Electronic governing, PTO speed control
    • Programmable ratings
    • Cold start capability to -20° C (-4° F)
    • Automatic altitude compensation
    • Power compensation for fuel temperature
    • Programmable low and high idle and total engine limit
    • Electronic diagnostics and fault logging
    • Engine monitoring system SAE J1939 broadcast and control
  • Cooling System
    • Thermostats and housing, vertical outlet
    • Jacket water pump, centrifugal
    • Heat exchanger installed
    • Expansion tank
  • Exhaust System
    • Exhaust manifold, dry
    • Dual turbo: exhaust elbow, dry 203 mm (8 in)
  • Flywheels And Flywheel Housing
    • SAE No. 1 flywheel
    • SAE No. 1 flywheel housing
    • Power take-off (PTO) flywheel stub shaft
  • Fuel System
    • Electronic unit injector
    • Fuel filter, secondary (2 micron high performance)
    • Fuel transfer pump
    • Fuel priming pump
    • Fuel sample valve, mounted on fuel filter base
    • Primary fuel filter
    • Water separator
  • Instrumentation
    • Instrument panel, LH
    • Engine oil pressure gauge
    • Voltmeter gauge
    • Water temperature gauge
    • Tachometer/engine hour meter
  • Lube System
    • Open crankcase ventilation system
    • Oil cooler
    • Lube oil filter
    • Front sump oil pan
    • Oil filler
    • Oil dipstick
    • Oil pump
  • Mounting System
    • Front and rear support
  • Protection System
    • Stop-Start System, automatic (compatible with NFPA 20 requirements, able to be energized from either of two battery sources and capable of manual starter actuation)
  • Starting System
    • 24 volt, LH electric starting motor
    • Jacket water heater (3 kW, 120-240 volt)
  • General
    • Vibration damper
    • Lifting eyes
    • Automatic variable timing, electronic
    • Electronic installation kit, 70 pin connector (connectors, pins, sockets)